CountZ Posted May 5 Share Posted May 5 Hi, the manual says, there should be a setting to control what the plug does when it gets power, but I can not find it in firmware 1.3? This is a rather important feature and not something that should get removed. Quote Link to comment Share on other sites More sharing options...
Shelly Olsche Posted May 5 Shelly Share Posted May 5 You will find it in input/ output settings Quote Link to comment Share on other sites More sharing options...
CountZ Posted May 7 Author Share Posted May 7 I do not use the app. Where can I find the setting in the web interface? Quote Link to comment Share on other sites More sharing options...
Shelly Olsche Posted May 7 Shelly Share Posted May 7 Home -> Klick on OUTPUT-Bar above where also the button is -> Input/Output-Settings: 1 Quote Link to comment Share on other sites More sharing options...
Heinz Posted May 7 Share Posted May 7 Snap @Olsche you sent the reply before me 😄 1 Quote Link to comment Share on other sites More sharing options...
CountZ Posted May 9 Author Share Posted May 9 (edited) Thank you both. I was sure, I clicked on outputs, but it seems I did not... . The plug was set to default off, but the problem seems to be home assistant and the shelly addon. They just do not recognize the state of the plug, after it gets power. If the plug was turned on, when it looses power, home assistant reports it as still turned on, after the power comes back. Edited May 9 by CountZ Quote Link to comment Share on other sites More sharing options...
Heinz Posted May 13 Share Posted May 13 all good at least the solution was found Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.