elsdeniep Posted August 29 Share Posted August 29 (edited) After setting a fixed IP address (on the router) for my Shelly dimmer 2, the dimmed lights switch off after a about 5 seconds. If I set it below 20% intensity however, the lights stay on. I have tried the following: - change the button type - reverse inputs - undo fixed ip address - run calibration - device reboot Is this a known issue? What could I try to solve this? Thanks in advance for any suggestions. Edited August 29 by elsdeniep Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
Heinz Posted August 29 Share Posted August 29 Does the device switch off completely or just disconnect from the network? Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
elsdeniep Posted August 29 Author Share Posted August 29 (edited) The lights switch off. The dimmer stays connected to the wifi network. (I have edited the start of the topic since it was not very clear indeed) Edited August 29 by elsdeniep Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
Heinz Posted August 29 Share Posted August 29 have you tried doing a hard reset of the device and then just to be sure check the firmware version and see what it does Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
elsdeniep Posted August 29 Author Share Posted August 29 (edited) I will try that tonight. What exactly is a hard reset: back to factory settings via the interface of the dimmer? Edited August 29 by elsdeniep Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
elsdeniep Posted August 29 Author Share Posted August 29 Update: I have downloaded and installed beta version of the device software and now it is working... 1 Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
Heinz Posted August 29 Share Posted August 29 6 hours ago, elsdeniep said: I will try that tonight. What exactly is a hard reset: back to factory settings via the interface of the dimmer? yup factory reset. the idea was to remove any strange settings if it had any but good that the firmware worked Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.