Jay Posted July 13 Share Posted July 13 (edited) I am wiring my garage door opener. I can open and shut the door, but the sensor does not change states depending on the status. The light on the app is always red. I have tested the reed switch for continuity with a voltmeter prior to installation and when I approach and distance the magnet it works as intended. Any suggestions? Edited July 13 by Jay Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
horkatz Posted July 14 Share Posted July 14 3 suggestions: Change the mode from Button to switch, change "Set relay power on default" to Turn OFF (with your setting the door opens after retrieving power, and, finally, overwork your wiring (too much copper visible). Best regards 😎 Horst Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
Heinz Posted July 15 Share Posted July 15 as @horkatz mentioned change those settings and please make sure the copper is not exposed and has a flush connection its good practice and safer that was never know what might just go across the cables and any point Quote Translate Revert translation? English (American) Finnish French German Italian Portuguese (European) Spanish Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.