alto Posted June 14 Share Posted June 14 I have a strange issue where my Plus Plug S starts to boot loop after I configure the MQTT prefix, broker and credentials. The device asks to reboot, but after confirming that it starts up with the LED lights in sequence: RED RED RED YELLOW/GREEN, and is not accessible over IP. I have factory reset the device several times and it is consistently fine while setting up wifi, changing device name and disabling the LED state indicator, but every time after I configure MQTT it just flips out and goes into a boot loop again. My firmware version is updated to 1.3.2. Wondering if anyone else has seen this behavior? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.