Jump to content
Shelly IoT Innovation Challenge started! ×

Shelly Pro 2 for 25A load


Recommended Posts

Posted (edited)

I need a programmable switch for remote control of one 25A channel. May I combine both two outputs of Shelly Pro 2 in one for that?
If yes, can the commands of one of the outputs be synchronized with another in order not to duplicate commands each time?
If not, is there any other Shelly device I can use for the remote control of 25A channel?

Edited by Vilnis
Link to comment
Share on other sites

Could it be any 25A general-purpose contactor like Schneider Electric Acti9 iCTK (manuf. ID A9C40125)?
I have to control the 25A channel with a 3kW heater and a few LED lights.   
 

Link to comment
Share on other sites

On 6/7/2024 at 11:36 PM, Vilnis said:

Could it be any 25A general-purpose contactor like Schneider Electric Acti9 iCTK (manuf. ID A9C40125)?
I have to control the 25A channel with a 3kW heater and a few LED lights.   
 

Whatever 16A+... the MCB can also be replaced with 16A variation. And that MCB's job is to be overload caused over temperature shield for wiring. But more easy to find 25A than 16A single phase contactor.

ps. Support your local electrician!

 

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...