Shelly Dimmer Pro 1PM: No Input State over MQTT

[DaOptika]

Hi,

• for the Shelly Dimmer 2 (and all other Shelly Gen1 with Inputs), there was always an Input Status available:
  shellies/shellydimmer2-wohnspots/input/0
  --> Very easy to operate the devices in detached mode.
   
• Also for Shelly Plus 2.5 (Gen 2), there's a:
  shellies/shellyswitch25-bad/status/input:1/state
  --> Also super easy to handle!
• For Shelly Dimmer Pro 1PM, I only have
  shellies/shellyprodm1pm-flur/status/input:0/id  --> no state 🙁

The only info about the switch state is in the notifications, but I cannot use this for switching the light on and off.

{
	"src":"shellyprodm1pm-xxxx",
	"dst":"shellies/shellyprodm1pm-flur/events",
	"method":"NotifyEvent",
	"params":
		{
			"ts":1709312293.77,
			"events":[{"component":"input:0", "id":0, "event":"btn_down", "ts":1709312293.77}]
		}
}

Can you please re-introduce shellies/shellyprodm1pm-flur/status/input:0/state in the next firmware?

Thanks and best regards,

Manuel