Shelly Pro Dimmer 2PM - Ok if impulse signal and life wire protected through different fuses?

[ChristophE]

Hi, 

I have two Eltako S12-100 impulse switches installed, which I like to replace with Shelly Dimmer Pro devices.

- The two existing switches have incoming impulses and live wires all of the same phase.
- The two switches are protected by the same ground fault circuit interrupter.
- However, each switch (incoming impulse + the live wire) has a separate fuse for its protection.

Is this a supported setup for using a single Shelly Dimmer Pro 2PM? Or do I need to use two separate shelly Dimmer Pro 1PM devices in the above case?

Thanks and best regards,

Christoph