Scene not doing anymore what its supposed to do

[Petz]

Good morning,

Unfortunately I couldn't find an answer using the search, here's what I'm experiencing:

I have a Shelly Button1 triggering a Shelly1 Mini Gen3 Relay.

I set this up via a scene, short push triggers the relay, relay is programmed to shut off after 150sec.

This worked fine for several months, but now the scene doesn't do anything anymore.

The button activity is properly logged, the relay reacts properly and is logged, firmwares up to date,
but seems like the scene doesn't exist anymore (Id 1710058488281).

Also tried to set up a new scene (1732483929814), didn't work either.

Super basic setup, what's the catch here?

Thanks a lot!

Patrick

Edited November 25 by Petz

[Heinz]

@Petz

Could you share a screenshot of the Scene setup? Additionally, please double-check that the device's IP address hasn't changed and confirm which server you are currently connected to.

[Petz]

OK, while checking the IP adrresses, I found the (obviously much simpler) reason... Scene didn't do anything because it was not "enabled" . Discovered that feature by chance; switched it to "enable", now it works.

@Heinz Thanks a lot for your precious help!

Edited November 26 by Petz

[Heinz]

On 11/26/2024 at 9:01 AM, Petz said:

OK, while checking the IP adrresses, I found the (obviously much simpler) reason... Scene didn't do anything because it was not "enabled" . Discovered that feature by chance; switched it to "enable", now it works.

@Heinz Thanks a lot for your precious help!

was a easy fix then 🙂