Control 230VAC using 24VDC

[Mathias92]

Hi,

I have a IHC installation in my house and would like to exchange the controller and all the outputs to shelly devices.

The IHC installation is using 24VDC in all pushes around the house and would like to keep that.

Therefore, I was thinking that the Shelly Pro 2 would be able to re-use the 24VDC pushes and then control the 230VAC outlet and lights. So 24VDC on the SW 1 and SW 2 to control 230VAC on I1/O1 and I2/O2.
However, in the new version of the Shelly Pro 2 it says something like it won’t be able to use 12 VDC anymore and it does not say anything about the 24VDC option.

So will it be possible to use the Shelly Pro 2 for this or is there some other Shelly devices that I should use?

Thanks!