Incorrect Display of X- Shellx Devices on the WD

[Aschi]

Hello everyone, 

I have questions about the X-Shelly in connection with the Shelly Wall Board. 

The individual relays/outputs of the X-Shelly can all be addressed and switched individually in the cloud as normal. 

If I set up new devices / buttons for the individual relays on the wall display, each relay is displayed as desired. 

However, it is not possible to switch the relays on/off !!

If the status of the relay is switched in the cloud or directly via the X-Shlelly WBM, the background color of the device on the wall display changes, so the status information is transmitted correctly. 

As a work-around, I have created a group on the wall display in addition to the direct device buttons.  In these groups, only the corresponding X-Shelly relay is entered as the target. 
This gives you a red/green button with which you can switch the relay.  The tile next to it with the relay then shows the status. 

Why doesn't the targeted addressing of the relays work directly? 

Another bug, : 

Several temperature sensors are connected to the sensor interface of the X-Shelly. 
Are these then specifically assigned to the relays in the WBM of the Shelly? 
all values of the temperature sensors are available on the buttons in the cloud for the individual buttons/devices. 
A specific assignment of the temperature sensors is not possible. !

The values of the sensors are also not shown on the device tile in the wall display. 
Another Shelly with an addon and Temp Sensor displays this as desired on the device tile

 LG 

Thomas