Jump to content
🌟 NOTIFICATION/Benachrichtigung: Welcome to our New Store! - shelly.com 🌟 ×

Shelly Plus 1 PM + Shelly Plus Add voltage not updated without reboot


MCowA

Recommended Posts

I'm using Shelly Plus 1 PM + Shelly Plus Add for electrical floor heating and reading the voltage over NTC sensor to Home Assistant where it is converted to temperature.

Issue with the Add On voltage is that it does not update values. It might be related that voltage changes are so small that that change is not triggered. I have now forced reboot every 5 minutes from Home Assitant to Shelly Plus 1 PM to get exact temperature values from the add on. Basically the values would be required to be updated at least with two decimals (0.01 V) accuracy.

So either forced update for values with some time (selectable?) schedule or updates with smaller voltage increments would be required to control floor heating with these two devices combined.

 

EDIT: I just realised that this is in wrong section, should be under "Devices >Shelly Plus (Gen2) devices >Shelly Plus Add-on". If possible, can admins move to correct section?

Edited by MCowA
wrong section
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...