How to make your Roller shutter smart with the Shelly 2PM.

[Heinz]

The Shelly 2PM is a versatile device that allows you to automate and add smart control to your motorized roller shutter.

To make your roller shutter smart you can use the following device. Shelly 2PM, Shelly Wave Shutter, Shelly Pro 2 PM, and the Shelly Pro Wave Shutter. 
 

To get started, follow these steps:

Begin by installing the Shelly 2PM according to the provided wiring diagram. Refer to the image and video below for detailed instructions on how to complete the installation process.

Switch mode.

Button mode. 

Note:  This can also be done with a single button have a look further down for that setting. 

Here’s a video example demonstrating the shutter mode installation for a Z-Wave device, but the concept is the same for the Shelly 2PM. Feel free to explore the YouTube channel to find the specific example you need.

 

The next step is to add the device to your Shelly 2PM to the network and to the Shelly app. Below the link that can help you. 

 

Once your Shelly device is installed and added to the app, the Shelly 2PM will appear as two devices, as shown below. The next step is to configure it to run in roller shutter mode.

Before proceeding to the next step, ensure that the device is updated to the latest firmware. To do this, click on the settings cog and select "Update Firmware."

Now we can begin configuring the settings to transform the Shelly 2PM into a smart roller shutter.

Select the Shelly 2PM, click on the settings cog, and navigate to the Device Profile.

Select the "Cover" option in the drop-down menu and click "Save".

Note: Your device will need to reboot after this setting is applied. Once it reboots, you will see the Shelly 2PM change from two individual relays to a single relay with up and down arrows.

The next step is to select the correct input type, Button, or Switch type select the correct input type and click Save

The next step and also an important step is to start the calibration. If you do not do the calibration this can hurt the motor and you can not see the position of your roller shutter. Find the Calibration option and click on Start calibration.


below is what you can see when you did not do the calibration. 

After the calibration 

 

The calibration process will take a few minutes, during which the device will move from the top to the bottom and then back up to the top. After that, it will gradually descend in stages until the calibration is done. 

Note: Ensure that there are no obstacles in the way during the calibration process.

 

Extra Information

Within the Shelly app, you have the option to reverse the inputs and directions. This allows you to change the arrow directions or reverse the movement direction as needed in the app.

When you have a single button you can go to the Control button mode and select the options from the settings according to the type of setup you have. 



By following the following steps your are have now made your manual roller shutter smart. 


 

[wooly]

If you use a single button would be also possible to set it as detached, the set as action for double click "open", for triple click "got to 51%" and for long click "close".
To stop you may create the action "stop" triggered by "button push" "repeat when 1" and as URL called "http://localhost/rpc/Cover.Stop?id=0" since there is not a native action "stop"