How do I wire 1PM mini to Light Switch L2 and L3 UK

[BM007]

My light switch has 3 wires, 1x brown or Red that is connected to L1 on the switch, 1x blue which is wired to L2 on the switch and 1x yellow that is not connected to anything. How do I wire this up to a Shelly 1PM mini? 

[Heinz]

can you take a picture. 


Electricity still works the same way regardless of where you are in the world 

1 x cable will be phase 
1 x cable will be neutral
1 x cable will be earth 

in your case, I'm guessing it will be the following 

Brown/red = Phase 
Blue = Neutral 
Yellow = Earth 

this can be tested with a multimeter to confirm that this is the case 
Here are the wiring diagrams on how it should be wired. But you need to make sure that the cable combinations are correct 

https://community.shelly.cloud/gallery/category/43-shelly-plus-1-pm-mini/

[Jose Antonio]

Hola….alguien me podría decir cómo puedo hacer para que un shelly 1PM mini solo se active en una franja horaria 22:00 a 07:00, solo cuando el sensor de movimiento detecta movimiento de personas. Se encendería durante 5 minutos.

gracias

[wooly]

No robar el thread !
Ponga la entrada como "butón-destconectado" y haz una acción pos eso butón como ControlOutput/on/flipback300.
esta acción tiene que tener ActiveTime 22:00-07:00

Edited January 14 by wooly

[Jose Antonio]

Good !!! Thank….