Reusing other inputs in RGBW mode for HomeAssistant

[Revinor]

I would like to setup RGBW PM in the mode that one of the inputs is controlled by the device (on/off, hold for brightness change), while other inputs should be just reported as events to home assistant (where I can fire up some scene changes, turn off all lights, whatever).

I have seen a possibility to completely detach inputs from the relays, but then home assistant is not seeing anything at all, plus no choice of leaving one switch enabled.

Is it possible?

For the detached mode, do I need to use MQTT to get button events into Home Assistant?

[Dreckfresse]

3 hours ago, Revinor said:

RGBW PM

Ich habe keinen RGBW PM 😉 aber 

wenn aber an einem Shelly der detached Modus aktiviert wird ändert sich in HA eigentlich nichts. Detached wird ja nur der SW Eingang vom Shelly.

kannst aber trotzdem die Eingänge am SW überwachen in HA und auch darauf reagieren.

diese musst du aber aktivieren in HA