Jump to content
Gen2 Devices: FW Update Required / Gen2 Geräte: FW-Update erforderlich ×

Shelly RGBW2 to drive relays UI question


Recommended Posts

NEED: I am trying to control a variable speed pool pump that allows for remote control of 4 relays using 5V.  Closing 1 of the 4 relays triggers a pre-set pump RPM and duration.

QUESTION: Does the RGBW2 interface have an option to use each channel as its own control/switch, set to full "LED intensity" (on or off) to drive a relay, and "optionally" lockout multiple channels being active at the same time?  This latter would allow it to act as 4 independent relay drivers or as an interlock-out switch.  If this was possible, I could use the RGBW2 to drive 12V relays that would then provide dry contacts for the 5V pump.


The picture is the wiring for the pump relays.

RGBW2 Relay Driver.png

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...